Operator's Manual

14
Operating the Attachment Lift
Lever
The attachment lift lever (Fig. 31) is used to raise and
lower various attachments.
Raising an Attachment
1. Depress the brake pedal to stop the machine.
2. Pull the attachment lift lever rearward until the latch
locks. In this position the lift will hold the attachment
in the up, or raised position.
Lowering an Attachment
1. Depress the brake pedal to stop the machine.
2. Pull the attachment lift lever rearward, to release the
lift pressure, and push the button on top to release the
latch. Move the lift lever forward to lower the
attachment.
m–6531
2
1
Figure 31
1. Lift lever 2. Button
Adjusting the Lift Chain
Rotating tines can cut hands, feet or other body
parts.
• Keep away from the rotating tines while
operating the tiller.
• Keep your hands, feet, and any other part of
your body or clothing away from rotating
parts.
• Before adjusting, cleaning, repairing and
inspecting the tiller, lower the tiller and loader
arms to the ground and turn off the engine.
Remove the key.
Warning
Changing the lift chain link at the clevis, affects
maximum tilling depth and transport lift height. These
links can be changed at the clevis (Fig. 32).
1. For maximum tilling depth, but reduced transport lift
height, lengthen the lift chain (Fig. 32).
2. For greater lift height, shorten the length of the lift
chain (Fig. 32). This position will have reduced tilling
depth.
1
Figure 32
3. Lift chain
3. For variations of less than a link in range, disconnect
chain from adjustable yoke on lift rod, loosen jam nut
and rotate the yoke clockwise to increase lift height
and tilling depth and counter clockwise to reduce lift
height and increase tilling depth (Fig. 32).