Operator's Manual

Installation
5
Mower Preparation
Remove Recycler

Baffles
1. Tilt mower into the vertical position, refer to;
Tilting the Mower, page 13.
2. Remove locknuts, carriage bolts and the
Recycler

baffles from the mower (Fig. 1).
Note: Save all hardware for use when
installing Recycler

baffles.
1
m-3562
2
3
Figure 1
1. Recycler

baffle
2. Carriage bolt
3. Locknut
Install Bagger and Discharge Baffles,
Chute Latch and Spring
1. Locate the left and right bagger baffles inside the
mower and secure with (6) 5/16–18 x 3/4”
(19 mm) carriage bolts, through from the bottom
of mower, and (6) 5/16” locknuts (Fig. 2).
2. Locate the left and right discharge baffles inside
the mower and secure with (4) 5/16–18 x 3/4”
(19 mm) carriage bolts, through from the bottom
and inside of mower, and (4) 5/16”
locknut.(Fig. 2).
3. Mount latch on chute and hold against rear of
mower. If holes are not drilled, mark, center
punch and drill two 17/64” (7mm) holes in
mower for latch.
4. Locate the latch on top of the mower and secure
with (2) 10–24 x 1/2” (13 mm) screws, through
from the bottom of mower, and (2) 10–24
locknut (Fig. 2).
5
1
6
3
m-3544
7
2
4
3
2
4
Figure 2
1. Bagger baffle
2. Locknut 3/8”
3. Carriage bolt
5/16–18 x 3/4” (19 mm)
4. Discharge baffle
5. Latch
6. Screw 10–24 x 1/2”
(13 mm)
7. Locknut 10–24
5. Attach spring bracket below traction unit control
plate with existing rear center bolt, down from
the top, and locknut (Fig. 3). Hook chute spring
into bracket
3
m-3563
1
4
2
Figure 3
1. Spring bracket
2. Existing bolt
3. Existing locknut
4. Spring