Operator's Manual

Installation

Loose Parts

Note: A rear-mount Attach–A–Matic, which must be purchased separately, is required for this blade. Use the chart

below to identify other parts used for assembly.

Note: Skids are available for the blade. They can be useful on rough or broken surfaces to keep the blade above the

ground. Contact your authorized Toro dealer for more information.

DESCRIPTION QTY. USE

Blade assembly

Rod

Cotter pin, 1–1/4 in. (30 mm)

Frame assembly

Bolt, 3/4–16 x 3-3/4 in. (95 mm)

Lock nut, 3/4 in.

Control handle

Cable

Angle control rod

Cable bracket

Hairpin cotter—large

Cotter pin, 1 in. (25 mm)

Assembling the blade

Lift link—slotted

Lift link—two hole

Clevis pin, 3/8 x 1 in. (25 mm)

Clevis pin, 3/8 x 3/4 in. (19 mm)

Hairpin cotter—medium

Attaching the center of the blade frame to the

tractor

Stabilizer

Bolt, 5/16 x 1–1/4 in. (32 mm)

Locknut, 5/16 in.

Attaching the stabilizer

Clevis pin, 3/8 x 1 in. (25 mm)

Hairpin cotter—small

Preparing the tractor attachment lift

Assembling the Blade

1. Lift and rotate the channel assembly so its holes align

with the lower blade mounts. Slide the rod through the

holes and secure it with two 1 in. (26 mm) cotter pins

(Fig. 1). Bend the ends of the cotter pins to secure the

rod.