Operator's Manual

10
1
3
1282
2
Figure 3
1. Rear shield
2. Cotter pin 1 in.
3. Slot
6. Attach lift chain, short link end, to lift bracket with
clevis, clevis pin and secure with 3/4 in. cotter pin
(Fig. 4).
2278
1
2
3
5
4
Figure 4
1. Short link
2. Clevis
3. Clevis pin
4. Bracket
5. Cotter pin 3/4 in.
Tractor Set-Up
1. Remove and save carriage bolts at fender mount under
the seat and attaching footrests. (Fig. 5).
2. Unplug seat wiring harness connector and remove wire
harness from wire clip.
3. Remove the fender\seat pan from the tractor.
Note: Save all hardware for use when re-installing
fenders.
1229a
1
2
2
2
2
Figure 5
1. Fender\seat pan 2. Carriage bolt
4. Remove rear panel behind gas tank (Fig. 6). Save all
hardware for use when installing rear panel.
2275
3
2
1
Figure 6
1. Rear panel
2. Washer
3. Bolt
5. Remove screws, washers and spacers (some models
only) at front of fuel tank. Lift front of fuel tank and
slide forward for clearance (Fig. 7).
1298
1
2
3
Figure 7
1. Screw
2. Washer
3. Spacer (some models
only)
6. Slide a shim washer and bushing onto ends of lift lever
rod. (Fig. 8).