Operator's Manual

5
2. Install the front weight to the bottom footrest frame
with 2 bolts (3/8 x 2–1/4 inch), 4 washers (3/8 inch) and
2 nuts (3/8 inch) (Figure 3).
Note: Make sure the weight is installed as shown in
Figure 3.
3. Install the footrest into the footrest frame while placing
the rods in the same hole positions (Fig. 2).
2
4
m–6686
5
4
3
1
Figure 3
1. Footrest frame
2. Bolt, 3/8 x 2–1/4 inch
3. Front weight
4. Washer, 3/8 inch
5. Nut, 3/8 inch
Important When you remove the twin bagger,
remember to remove the front weight.
Installing the Quick Attach
Bracket
1. From the back of the mower, slide the quick attach
bracket along the outside of the rear frame.
2. Align the holes in the rear frame and the bagger
mounting bracket (Fig. 4).
3. Secure the bagger mounting bracket to the rear frame
with 4 bolts (3/8 x 1 inch), 4 washers (3/8 inch), and
4 locknuts (3/8 inch) (Fig. 4).
m–6626
3
5
2
2
1
4
Figure 4
1. Quick attach bracket
2. Bolts, 3/8 x 1 inch
3. Locknut, 3/8 inch
4. Rear frame
5. Washer, 3/8 inch
Assembling the Bagger
Note: If the frame assembly is not installed to the bagger
cover, use the following instructions for installing it.
1. Install the frame assembly to the bagger cover with 2
locknuts (1/4 inch) (Fig. 5).
1
3
1849
2
Figure 5
1. Frame assembly
2. Bagger cover
3. Locknut, 1/4 inch