Operator's Manual

13
If you remove the spring-loaded bagger top when
it is closed (in the down position), the top may
suddenly fly open and you or someone else may be
bruised, pinched, or injured in another way.
Always open (raise) the bagger top before you
remove or install it on the quick-attach bracket.
Caution
3. Remove the plates and fasteners from the quick-attach
bracket (Fig. 25).
4. Remove the hairpin cotter from the hole at the bottom
of the quick-attach bracket (Fig. 25).
5. Slide the bottom of the quick-attach bracket up out of
the hole in the hitch (Fig. 25).
m–5327
1
2
3
Figure 25
1. Quick-attach bracket
2. Plate
3. Hairpin cotter
Removing the Blower
1. Remove the blower belt cover by removing the 2
locknuts (5/16 in.) and 4 washers (Fig. 26). Retain all
parts for future installation.
m–4840
1
3
2
2
Figure 26
1. Blower belt cover
2. Washer
3. Locknut, 5/16 in.
2. Open the latch and swing the blower out, away from the
mower. Remove the blower belt from the idler and
blower pulleys (Fig. 27).
1
2
3
m–3557
Figure 27
1. Idler pulley bracket and
pulley
2. Top side of belt against
bottom pulley
3. V-side of belt into top
pulley