Operator's Manual

Figure8
1.Handleassembly
4.Nut(3/8inch)
2.Bolt(3/8x1-1/4inches)
5.Thisboltisnotusedon
Kubotapoweredmachines
3.Washer
3.Installthebaggerarmlinkagetothebaggerassembly
withaclevispinspring(Figure9).
Figure9
1.Baggerarmlink
3.Clevispinspring
2.Baggerassembly
4
TighteningallMountingBolts
NoPartsRequired
Procedure
Thefollowingstepsarethecorrectsequencetotighten
thesidebracketsandthebaggermountingbracket.All
mountingboltsneedtobetorquedto35ft-lb(48N⋅m).
1.Tightenthebaggermountingbrackettotherear
framerst.
2.TightentheROPSandsidebracketstothesideof
themower.
3.Ifthebaggermountingbracketmovessidetosidean
1/8inchormore,installoneorbothofthespacers
betweenthebaggermountingbracketandmounting
plates(Figure4,Figure5,andFigure6).
4.Tightenthebaggermountingbrackettotheside
brackets.
5
InstallingtheBagger
Assembly
Partsneededforthisprocedure:
1Baggerassembly
2
Clevispin
2Hairpincotter
Procedure
1.Installthebaggerassemblyontothebagger
mountingbracket(Figure10).
2.Installthe2clevispinsintothebaggerassemblyand
baggermountingbracket.Secureitwith2hairpin
cotters(Figure10).
9