Operator's Manual

20
Transporting Machines
Do not leave grass or debris in the bagger while
transporting the machine.
Transporting the machine with grass or debris in
the bagger can damage the machine.
Do not leave grass or debris in the bagger while
transporting the machine.
Warning
Operating and Bagging Tips
Machine Size
Remember that the machine is longer and wider with this
attachment installed. By turning too sharply in confined
places you may damage the attachment or other property.
Trimming
Always trim with the left side of the mower. Do not trim
with the right side of the mower because you could damage
the bagging tubes.
Cutting Height
For optimum bagging performance, set the deck
height–of–cut to remove no more that 2 to 3 inches (51 to
76 mm) or 1/3 of the grass height, which ever is less.
Cutting off more than this will reduce the capacity of the
vacuum system.
Cutting Frequency
Cut the grass often, especially when it grows rapidly. You
will have to cut your grass twice if it gets excessively long
(refer to Bagging Long Grass, page 20).
Cutting Technique
For best lawn appearance, be sure to slightly overlap the
mower into the previously cut area. This helps reduce the
load on the engine and reduces the chance of plugging the
boot and tube.
Bagging Speed
The bagging system may plug if you drive too fast and the
engine speed gets too slow. On hills it may be necessary to
slow the machines ground speed. Mow down hill whenever
possible.
As the bagger fills, extra weight is added to the
back of the machine. If you stop and start
suddenly on hills, you may lose steering control or
the machine may tip.
• Do not start or stop suddenly when going uphill
or downhill. Avoid uphill starts.
• If you do stop the machine when going uphill,
disengage the PTO. Then back down the hill
using a slow speed.
• Do not change speeds or stop on slopes.
Caution
Bagging Long Grass
Excessively long grass is heavy and may not be propelled
completely into the bagger. If this happens, the tube and
boot may plug.
Bagging Wet Grass
If possible, always try to cut grass when it is dry. Wet grass
can cause plugging.
Reducing Plugging
To avoid plugging the bagging system, reduce ground
speed and mow the grass at a high height-of-cut, then lower
the mower to your normal cutting height and repeat the
bagging process.
Signs of Plugging
As you are bagging, a small amount of grass clippings
normally blow out the front of the mower. An excessive
amount of clipping blow-out indicates that the bagger is
full or the boot is plugged.