Operator's Manual

Installation
9
6. Raise the carrier frame and roll the mower away
from traction unit.
7. Lower carrier frame and remove hairpin cotters
and pivot pin assemblies securing push arms to
traction unit clevises (Fig. 14).
Note: Save all hardware for use when
installing mower.
2
m-3195
4
3
1
Figure 14
1. Clevis
2. Push Arm
3. Pivot Pin Assembly–flat
4. Hairpin Cotter
8. Remove (2) 3/8”–16 x 1-5/8” (41.5 mm) bolts
and 3/8”–16 locknuts from universal joint and
slide the driveshaft off gearbox shaft (Fig. 15).
Note: Save all hardware for use when
installing mower.
1
2
4
m-3198
3
5
Figure 15
1. PTO Driveshaft
2. Universal Joint
3. Gearbox shaft
4. Bolt 3/8”–16 x 1-5/8”
(41.5 MM)
5. Locknut 3/8”–16