Service Manual

8-14
Digital Edition - TITAN® HD Service Manual
January 2018
Table of Contents
MOWER DECK
Mower Deck
Installation (Cont.)
5. Install the mower belt see “Mower Belt Replacement,” chapter 8, page 8-5.
6. Install the mower belt covers.
7. Raise the deck to the 3 in. (76 mm) height-of-cut position and check for deck level see “Leveling the Mower
Deck,” chapter 8, page 8-19.
8. Connect the battery terminals and verify proper function of the unit.
9. For 60 in. Decks Only:
-Raise the deck to the transport position (5 in. or 127 mm).
-Install the lift assist spring adjusting screw previously removed.
-Slowly adjust the screw on the lift assist spring until a gap of 7/8 in. to 1-1/8 in. is achieved (22-29 mm).
A B
C
Figure 13
A. Adjusting Screw
B. Bracket
C. Measure gap here