Service Manual

7-3
Digital Edition - TITAN® HD Service Manual
January 2018
Table of Contents
HYDROSTATIC DRIVE SYSTEM
Drive
Using the Drive Wheel Release Valves (Bypass Valves)
The drive wheel release valves are located on the left and right sides underneath the engine block.
1. Park the machine on a level surface and disengage the PTO. Stop the engine, wait for all moving parts to stop,
and remove the key. Engage the park brake.
2. Locate the bypass levers behind the seat near the drive wheels, on the left and right side of the frame (Figure
2).
3. To push the machine, loosen the hand screws, move both bypass levers rearward, and tighten the hand screws
to lock into place (Figure 2).
4. Disengage the park brake before pushing the machine.
5. To run the machine, move the bypass knobs to the forward position and lock them into place (Figure 2).
A
B
A
B
Rear Front
Figure 2
A. Run Position
B. Push Position (Disengage Park Brake)