Operator's Manual

Operation
15
Adjusting the Center Roller
The center roller guides the mower over uneven turf
without scalping the lawn. For most cutting
conditions it should be located in the lower hole.
When cutting in 1 1/2” height-of-cut, move the center
roller to the upper hole position.
1. Raise the attachment lift lever; refer to Raising
Attachments.
2. Remove the cotter pin, bolt and shaft to change
hole location (Fig. 27).
3. Select the hole position for the height-of-cut to
be used and insert the rod (Fig. 27).
4. Secure the rod with the bolt and cotter pin.
m
-
-
3
6
0
9
1
2
3
4
5
6
Figure 27
1. Roller
2. Cotter pin
3. Bolt
4. Rod
5. Upper hole
6. Lower hole
Adjusting the Front Wheels
The two front adjustable wheels must be adjusted in
the proper hole location for each time you change
deck height-of-cut position.
1. After selecting height of cut, make sure the front
adjustable wheels are approximately 3/8” (9.5
mm) off the ground.
2. To adjust wheel height off the ground, remove
the hairpin cotter and pin to change hole location
(Fig. 28).
3. Select a hole position so the wheel is
approximately 3/8” (9.5 mm) off the ground for
the height-of-cut position to be used (Fig. 28).
4. Insert the pin and secure it with a hairpin cotter.
5. Repeat this adjustment on the other wheel.
1233
1
2
3
Figure 28
1. Wheel
2. Pin
3. Hairpin Cotter