Operator's Manual

Disengaging the Power Take Off (PTO)

1. Push the power take off (PTO) to the off position

(Fig. 19).

Using the Attachment Power

Lift

The attachment power lift (Fig. 20) is used to raise and

lower attachments.

Raising Attachments

1. Turn key to the on or run position (Fig. 20).

2. Push the lift switch in the up direction to raise the

attachment lift (Fig. 20). This will lift and hold the

attachment in the up, or raised position.

Lowering Attachments

1. Turn key to the on or run position (Fig. 20).

2. Push the lift switch in the down direction to lower the

attachment lift (Fig. 20). This will lower the attachment

lift.

m–6513

Figure 20

1. Key

2. Lift switch —up

3. Lift switch —down

Operating the Attachment Lift

Lever

The attachment lift lever (Fig. 21) is used to raise and lower

various attachments.

Raising an Attachment

1. Depress the brake pedal to stop the machine.

2. Pull the attachment lift lever rearward until the latch

locks. In this position the lift will hold the attachment in

the up, or raised position.

Lowering an Attachment

1. Depress the brake pedal to stop the machine.

2. Pull the attachment lift lever rearward, to release the lift

pressure, and push the button on top to release the latch.

Move the lift lever forward to lower the attachment.

m–6531

Figure 21

1. Lift lever 2. Button

Adjusting the Height of Cut

The rear support wheels adjust for different heights of cut,

between 1-1/2 and 4-1/2 inch (4 to 11 cm).

1. Disengage the PTO and set the parking brake.

2. Stop the engine, remove the key, and wait for all

moving parts to stop before leaving the operating

position.