Operator's Manual

18
m-2430
2
3
2
1
Figure 28
1. Adjustable link
2. Front lift arm
3. Washer, 1/2 in.
4. Hairpin cotter-small
5. Remove small hairpin cotter and washer from rear link
and remove from attachment lift (Fig. 29).
6. Remove hairpin cotters and washers from rear lift arms
(Fig. 29).
7. Slide deck right, off rear lift arms (Fig. 29).
m-2445
1
3
2
5
4
76
Figure 29
1. Lift arms
2. Washer, 3/4 in.
3. Hairpin cotter-large
4. Attachment lift
5. Rear link
6. Washer, 1/2 in.
7. Hairpin cotter-small
8. Raise attachment lift all the way to the latched position.
Turn the front wheels, as necessary, and slide the
mower out to the the right side.
Note: Save all hardware, washers and hairpin cotters for
use when installing deck.
Storage
1. Clean dirt and chaff from the outside of the engine’s
cylinder head fins and blower housing. Also remove
grass clippings, dirt, and grime from the external parts
of the entire machine, especially the engine, shrouding,
and the top of the mower.
Important You can wash the machine with mild
detergent and water. Do not pressure wash the machine.
Avoid excessive use of water, especially near the control
panel, lights, engine, and the battery.
2. Wash the underside of the mower; refer to Washing
Underside of Mower, page 17.
3. Check the condition of the blades; refer to Servicing the
Cutting Blades, page 14.
4. Check the condition of the blade drive belt.
5. Grease the mower deck; refer to Greasing and
Lubrication, page 16.
6. Check and tighten all bolts, nuts, and screws. Repair or
replace any part that is damaged or defective.
7. Paint all scratched or bare metal surfaces. Paint is
available from your Authorized Service Dealer.
8. Store the machine in a clean, dry garage or storage area.
Remove the key from the ignition switch and keep it in
a memorable place. Cover the machine to protect it and
keep it clean.