Service Manual
Table Of Contents
- Revision History
- Preface
- Chapter 1 : Safety
- Chapter 2 : Specifications and Maintenance
- Chapter 3 : Troubleshooting
- Chapter 4 : Engine
- Chapter 5 : Chassis
- General Information
- Service and Repairs
- Caster Fork and Bearing Replacement
- Caster Wheel Replacement
- Left Console Replacement
- Right Console Replacement
- Seat Replacement
- Fuel Tank Replacement
- ROPS (Roll Over Protection System) Replacement
- Throttle Cable Assembly Replacement
- Choke Control Assembly Replacement
- Park Brake Handle Assembly Replacement
- Adjusting the Park Brake
- Motion Control Damper
- Motion Control Assembly Replacement
- Adjusting the Motion Control Handle Position
- MYRIDE® Replacement
- Chapter 6 : Deck
- Chapter 7 : Drive System
- Chapter 8 : Electrical
- Appendix A: Foldout Drawings
- Electrical Schematic
- Kawasaki Engine Electrical Schematic
LevelingtheMowerDeck(continued)
g336159
Figure68
1.Block7.3cm(2.87inch)
2.Welds
BlockHeightandRakeTable
DeckSize
BlockHeightRake
AllMowerDeck
7.3cm(2.87inch)4.8-6.4mm(3/16-1/4inch)
13.Rotatethebladesside-to-sidesothattheyareparalleltotherearofthedeck.
14.Loosenthelevelingadjustmentlocknutsonall4cornerssothatthedeckis
sittingsquarelyontheblocks.
15.Removeanyslackfromthedeckhangersandmakesurethedeckliftfoot
leverispushedbackagainstthestop.
16.Tightenthe4levelingadjustmentlocknuts.
17.Verifythattheblockstsnuglyunderthedeckskirtandthatallattachment
boltsaretight.
18.Continuelevelingthedeckbycheckingthefronttorearbladeslope.
19.Recheckthelevelofthebladesandrepeatdecklevelingprocedureif
necessary.
20.For60inchdecksonly:
•Raisethedecktothetransportposition.
•Installtheliftassistspringadjustingscrew(removedinstep7above).
•Setthegapbetweenthespringandthebracketto22–29mm(7/8-1-1/8
inches).
21.Connectthebatterybyinstallingthepositivecablerst,thenthenegative
cabletothebattery.
2000SeriesZMASTER®ServiceManual
Page6–11
Deck:ServiceandRepairs
3438-778RevA