Service Manual

ZT-2800
®
/ZT-3100
®
/ZT-3200
TM
/ZT-3400
®
23
FAN AND PULLEY
NOTE: It is necessary to remove the
transaxlefromthevehiclebeforeperformingthe
repairprocedurespresentedinthissection.To
remove the wheel from the hub, do so by
removing the lug nuts.  Do not remove the
axle/hub nut unless replacing the hub, the
axle seal or removing the axle shaft.
Beforestartinganydisassembly,makecertain
thatyourworkareaisneatandclean.Clean
theexternalpartsofthetransaxle.
Thefollowingproceduresarepresentedinthe
orderrecommendedforacompleteteardown
ofthetransaxle.
Donotdisassembletheunitanyfartherthan
necessarytoaccomplishtherequiredrepairs.
Reassembly is accomplished by performing
the“Assembly”portionsoftheprocedures.If
theunithasbeencompletelydisassembled,a
summaryoftheassemblyprocedures,inthe
orderinwhichtheyshouldoccur,isgivenon
page38.
Figure 16, Fan/Pulley Kit (207) Conguration “A”
RefertoFigure16
Disassembly

 


Inspection
 

 -

Assembly
 

 
       

NOTE: Asageneralrule,usethelowendof
the torque specication on fasteners
whenreassemblingtheunit.
TRANSAXLE REMOVAL
122
123
120
121