Service Manual
Table Of Contents
- Revision History
- Preface
- Chapter 1 : Safety
- Chapter 2 : Specifications and Maintenance
- Chapter 3 : Troubleshooting
- Chapter 4 : Engine
- Chapter 5 : Chassis
- General Information
- Service and Repairs
- Caster Fork and Bearing Replacement
- Caster Wheel Replacement
- Left Console Replacement
- Right Console Replacement
- Seat Replacement
- Fuel Tank Replacement
- ROPS (Roll Over Protection System) Replacement
- Throttle Cable Assembly Replacement
- Choke Control Assembly Replacement
- Park Brake Handle Assembly Replacement
- Adjusting the Park Brake
- Motion Control Damper
- Motion Control Assembly Replacement
- Adjusting the Motion Control Handle Position
- MYRIDE® Replacement
- Chapter 6 : Deck
- Chapter 7 : Drive System
- Chapter 8 : Electrical
- Appendix A: Foldout Drawings
- Electrical Schematic
- Kawasaki Engine Electrical Schematic
SeatRemoval(continued)
g336087
Figure31
1.Bolt
2.SeatPivot
6.Unlatchtheseat,thenmovetheseatrearward,outofthewayofthemotion
controlbox.Lifttheseatoffofthemachine.
SeatInstallation
1.Placetheseatontopofthefueltankretainerplate.
2.Movetheseatforward,aligningtheholesintheseatpanwiththeholesin
themotioncontrolbox.
Note:Makesuretheangebushingispresentineachsideoftheseatpan.
3.Installtheboltandseatpivotoneachsideoftheseat.
4.Raisetheseatandattachthewireharnesstotheoperatorpresenceswitch.
5.Liftandlowertheseattoverifyproperfunctionoftheseatpivotsandthe
seatlatch.
6.Connectthebatterybyinstallingthepositivecablerst,thenthenegative
cabletothebattery.
FuelTankReplacement
FuelTankRemoval
Note:Thefuelpick-upsystemisdesignedtopullfuelfromanypartofthetankin
lowfuelsituationsaswellasreducingtheaffectofdebrisinthetank.
Chassis:ServiceandRepairs
Page5–16
2000SeriesZMASTER®ServiceManual
3438-778RevA