Service Manual
Table Of Contents
- Revision History
- Preface
- Chapter 1 : Safety
- Chapter 2 : Specifications and Maintenance
- Chapter 3 : Troubleshooting
- Chapter 4 : Engine
- Chapter 5 : Chassis
- General Information
- Service and Repairs
- Caster Fork and Bearing Replacement
- Caster Wheel Replacement
- Left Console Replacement
- Right Console Replacement
- Seat Replacement
- Fuel Tank Replacement
- ROPS (Roll Over Protection System) Replacement
- Throttle Cable Assembly Replacement
- Choke Control Assembly Replacement
- Park Brake Handle Assembly Replacement
- Adjusting the Park Brake
- Motion Control Damper
- Motion Control Assembly Replacement
- Adjusting the Motion Control Handle Position
- MYRIDE® Replacement
- Chapter 6 : Deck
- Chapter 7 : Drive System
- Chapter 8 : Electrical
- Appendix A: Foldout Drawings
- Electrical Schematic
- Kawasaki Engine Electrical Schematic
ToroTwinCylinderEngineInstallation(continued)
g335893
Figure12
19.Connectthefuelsupplylinetothefuellter.
20.Installtheengineguard.
21.Openthefuelsupplyvalve.
22.Fillthecrankcasewithapprovedoilandverifyproperoillevel.
23.Connectthebatterybyinstallingthepositivecablerst,thenthenegative
cabletothebattery.
24.Verifyproperfunctionoftheunit.
Note:Verifyenginespeedissetto3600±50RPM(or3000±50RPM
forTEmodels).
KawasakiEngineReplacement
KawasakiEngineRemoval
1.ParkthemachineonalevelsurfaceanddisengagethePTO.Stopthe
engine,waitforallmovingpartstostopandremovethekey.Engagethe
parkingbrake.
2.Disconnectthebatterybyremovingthenegativecablerst,thenthepositive
cablefromthebattery.
3.Closethefuelsupplyvalve.
4.Removetheengineguard.
5.Removethemowerbelt.MowerBeltReplacement(page6–6)
6.Removethehydrostaticdrivebeltfromtheenginepulley.HydrostaticDrive
BeltReplacement(page7–8)
7.Disconnectthechassiswireharnessfromthemainenginewireharness.
2000SeriesZMASTER®ServiceManual
Page4–9
Engine:ServiceandRepairs
3438-778RevA