Service Manual
Table Of Contents
- Revision History
- Preface
- Chapter 1 : Safety
- Chapter 2 : Specifications and Maintenance
- Chapter 3 : Troubleshooting
- Chapter 4 : Engine
- Chapter 5 : Chassis
- General Information
- Service and Repairs
- Caster Fork and Bearing Replacement
- Caster Wheel Replacement
- Left Console Replacement
- Right Console Replacement
- Seat Replacement
- Fuel Tank Replacement
- ROPS (Roll Over Protection System) Replacement
- Throttle Cable Assembly Replacement
- Choke Control Assembly Replacement
- Park Brake Handle Assembly Replacement
- Adjusting the Park Brake
- Motion Control Damper
- Motion Control Assembly Replacement
- Adjusting the Motion Control Handle Position
- MYRIDE® Replacement
- Chapter 6 : Deck
- Chapter 7 : Drive System
- Chapter 8 : Electrical
- Appendix A: Foldout Drawings
- Electrical Schematic
- Kawasaki Engine Electrical Schematic
MotionControlDamperInstallation(continued)
3.Torquethefrontmountingboltto108-135N•m(90±10in-lb).
MotionControlAssemblyReplacement
MotionControlAssemblyRemoval
g336042
Figure50
1.ParkthemachineonalevelsurfaceanddisengagethePTO.Stopthe
engine,waitforallmovingpartstostop,andremovethekey.
2.Raiseandsupporttheunitsothatthedrivewheelsareofftheground.
Note:Theconsolemayberemovedforeasieraccess.LeftConsole
Replacement(page5–11)RightConsoleReplacement(page5–13)
3.Removethe2boltssecuringthemotioncontrolhandletothemotioncontrol
assembly.
4.Removethe2screwssecuringthemotioncontrolcovertotheframe.
5.Disconnectthemotioncontroldamperfromthemotioncontrolassembly.
6.Disconnectthemotioncontrollinkagefromthetransmission.
Chassis:ServiceandRepairs
Page5–28
2000SeriesZMASTER®ServiceManual
3438-778RevA