Service Manual

CHASSIS
3-54 Toro Z Master G3 3000/5000/6000 Series Service Manual
3
4. Align the levers front to rear position by bringing the
levers together to the neutral position and slide them
until they are aligned, then tighten the bolts (Fig.
190).
Fig. 190 g. 85 G009195
Motion Control Assembly
Replacement
Motion Control Assembly Removal
Note: This procedure is performed on the left hand
motion control assembly; follow the same
procedure for the right hand side.
1. Park the machine on a level surface, disengage
the PTO, turn the ignition key to OFF position and
remove the key.
2. Remove the 2 screws retaining the LH motion
control cover assembly (Fig. 191).
Fig. 191 DSCN-4454