Service Manual

MOWER DECKS

6-26 Toro Z Master G3 3000/5000/6000 Series Service Manual

16. On both sides of the deck, measure from the level

surface to the back tip of the blade (Position B). The

measurement should read 3-1/4” (8.3cm) (Fig 461).

15. Tighten the two bolts at the bottom of the height-of-

cut plate (Fig. 460). Torque to 27-33 ft-lbs. (37-45

Nm).

Note: In most conditions, the back blade tip should

be adjusted 1/4” (6.4mm) higher than the

front.

Fig. 460 g. 96 G017029

A. Bolts at the bottom of the height-of-cut plate

Fig. 461 g. 93 G009196

1. 3” (7.6cm) at A is 3. Measure here from

correct the blade tip to hard

2. 3-1/4” (8.3cm) at B surface

is correct 4. Measure at A & B on

both sides