Service Manual

MOWER DECKS
6-20 Toro Z Master G3 3000/5000/6000 Series Service Manual
6
Note: There is a snap ring located in the spindle
housing (Fig. 444). If replacing the bearings
and seals only, there is no need to remove the
snap ring, unless it shows damage.
Fig. 444 DSCN-0106a
Mower Spindle Assembly (2010 &
Later Model G3, 3000/5000/6000
Series Units)
Fig. 445 DSCN-0118a
2. Apply a lm of grease around the lip of the seal and
install the lip of the seal face inward (Fig. 446).
Fig. 446 DSCN-0119a
1. Install the bottom bearing. Press up against the snap
ring (Fig. 445).