Service Manual

HYDRAULIC SYSTEM
5-7Toro Z Master G3 3000/5000/6000 Series Service Manual
5
30. On the side of the machine being serviced, loosen
the 2 carriage bolts and nuts located on either side
of the UHT securing it to the cradle (Fig. 286).
32. Position a oor jack under the cradle on the side of
the machine being serviced. Raise the oor jack to
contact the cradle (Fig. 288).
29. On the side of the machine being serviced, remove
the bottom carriage bolt and nut securing the UHT to
the cradle (Fig. 285).
31. On the side of the machine not being serviced,
remove the 3 carriage bolts and nuts securing the
UHT to the cradle (Fig. 287).
Fig. 285 PICT-8605a
Fig. 286 PICT-8607a
Fig. 287 PICT-8615a
Fig. 288 PICT-8617