Service Manual

MOWER DECKS

6-29Toro Z Master G3 3000/5000/6000 Series Service Manual

Removing the Blades

4. Rotate the opposite ends of the blades forward.

5. Measure from a level surface to the cutting edge of

the blades at the same position as in step 3 above.

6. The difference between the dimensions obtained

in steps 3 and 4 must not exceed 1/8” (3mm). If

this dimension exceeds 1/8” (3mm), the blade is

bent and must be replaced; refer to “Removing the

Blades” on page 6-29 and “Installing the Blades” on

page 6-30.

WARNING

A blade that is bent or damaged could break apart

and could seriously injure or kill you or bystanders.

• Always replace bent or damaged blade with

a new blade.

• Never le or create sharp notches in the

edges or surfaces of blade.

Blades must be replaced if a solid object is hit, if the

blade is out of balance, or is bent. To ensure optimum

performance and continued safety conformance of

the machine, use genuine Toro replacement blades.

Replacement blades made by other manufacturers may

result in non-conformance with safety standards.

1. Hold the blade end using a rag or thickly padded

glove.

2. Remove the blade bolt, curved washer, and blade

from the spindle shaft (Fig. 465).

Fig. 465 g. 100 G004536

A. Sail area of blade C. Curved washer

B. Blade D. Blade bolt