Service Manual

HYDRAULIC SYSTEM

5-6 Toro Z Master G3 3000/5000/6000 Series Service Manual

25. Pull back the rubber boot, exposing the brake cable,

and slide the cable out of the cable anchor bracket

slot (Fig. 282).

26. Release the brake cable retainer holding the brake

cable to the cradle. Pull the retainer toward the end

of the cable and push the cable through the routing

holes so the slack is on the front side (Fig. 283).

Fig. 281 PICT-8655

Fig. 282 PICT-8591a

Fig. 283 PICT-8592a

27. Repeat steps 24 – 26 on the opposite side of the

machine.

28. Pull 2 or 3 inches of cable toward the center of

the machine and release the brake cable from the

retainers on the cradle (Fig. 284).

Note: Only the left hand brake cable is installed in

the cradle retainers.

Fig. 284 PICT-8649a

24. Squeeze the tabs on the brake cable and pull the

brake cable out of the slot in the cable anchor

bracket (Fig. 281).