Service Manual

HYDRAULIC SYSTEM

5-29Toro Z Master G3 3000/5000/6000 Series Service Manual

5. Loosely install three bolts and nuts securing the

cradle to the UHT transmission that was not servic-

ed. The oor jack might have to be repositioned to

align holes (Fig. 358).

Fig. 358 DSCN-4551a

A. Cradle to UHT nuts

B. UHT mounted frame bolts

7. On the side of the machine being serviced, tighten

the 3 bolts and nuts securing the cradle to the UHT

transmission and the 2 bolts securing the UHT

transmission to the frame, torque the nuts and bolts

to 75 ± 8 ft-lbs. (101.7 ± 10.8 Nm) (Fig. 359).

Fig. 359 DSCN-4550a

A A

8. Tighten the three bolts and nuts securing the cradle

to the UHT transmission on the side that was not

serviced. Torque them to 75 ± 8 ft-lbs. (101.7 ± 10.8

Nm) (Fig. 360).

Fig. 360 DSCN-4551a

Fig. 361 DSCN-4552a

9. Remove the oor jack.

10. Apply thread locking compound to the control arm

bolt (Fig. 361).