Operator's Manual

g190360
Figure92
1.Deck-liftpedal
3.Transportlock
2.Height-of-cutpin
6.Inserttheheight-adjustmentpinintothe7.6cm
(3inches)cutting-heightlocation.
7.Releasethetransportlockandallowthedeckto
lowertothecuttingheight.
8.Raisethedischargechute.
9.Onbothsidesofthedeck,measurefromthe
levelsurfacetothefronttipoftheblade(Postion
A).
Note:Themeasurementshouldread7.6mm
(3inches)asshowninFigure93.
g009196
Figure93
1.7.6cm(3inches)at
positionAiscorrect.
3.Measureherefromthe
bladetiptohardsurface.
2.8.3cm(3-1/4inches)at
positionBiscorrect.
4.MeasureatpositionAand
Bonbothsides.
10.Ifneeded,loosenthewhizlocknutonthesideof
theyokeandthejamnutontop.Finetunethe
screwadjusterbyturningittogeta7.6mm(3
inches)height(Figure94).
Note:T oincreasetheheight,turnthe
adjusterscrewclockwise;todecrease,turn
counterclockwise.
Note:Ifthefrontdecklinksdonothaveenough
adjustmenttoachieveaccuratecutheight,you
canusethesingle-pointadjustmenttogain
moreadjustment.
g010251
Figure94
1.Whizlocknut3.Jamnut
2.Adjusterscrew4.Yoke
11.Toadjustthesingle-pointsystem,loosenthe
2boltsatthebottomoftheheight-of-cutplate
(Figure95).
g029651
Figure95
1.Boltsatthebottomoftheheight-of-cutplate
12.Ifthedeckistoolow,tightenthesingle-point
adjustmentboltbyrotatingitclockwise.If
thedeckistoohigh,loosenthesingle-point
61