Service Manual

ManualsBrandsToro ManualsOutdoor Power EquipmentTimeCutter 54 in. IronForged Deck 23 HP Kawasaki V-Twin Gas Dual Hydrostatic Zero Turn Riding Mower with MyRIDE CARB

ZT-2100 / ZT-2200 (EZT

®

) 11

FLUID CHANGE PROCEDURE

This transaxle is factory lled, sealed and does

not require oil maintenance. However, in the

event of oil contamination or degradation, oil

addition or change may alleviate certain per-

formance problems.

1. Remove the transaxle from the vehicle.

NOTE: If removing the wheel from the

transaxle, do so by removing the four (4)

lug nuts. Do not remove the axle/hub nut.

2. Clean the oil ll port area of any debris.

3. Remove the oil ll port tting.

4. Position the transaxle so the oil will drain

completely out of the housing.

5. Fill the transaxle at the oil ll port according

to Figure 4.

6. Install the oil ll port tting.

7. Purging will be required. Refer to the purging

procedures on Page 12.

8. Recheck the uid level once the unit has

been operated for approximately 1 min-

ute.

Table 6. Fluid Volumes for the EZT

®

FLUID CHANGE

Figure 4. Fluid Level and Fill Port

TOP OF FILL PORT

OIL LEVEL

0.75” - 1.50” (19-38mm) depth

at 50°-100°F (10°-38°C)

Series Fluid Description Volume

ZT-2100 20W50 engine oil 54 . oz. / 1.687 qt. (1597 ml)

ZT-2200 (EZT

®

) 20W50 engine oil 56 . oz. / 1.75 qt. (1650 ml)