Service Manual
5-6
Table of Contents
Twin Cylinder Engine Service Manual
February 2017 - Digital Edition
ELECTRICAL SYSTEM AND COMPONENTS
Charging System Testing (Cont.)
OHM Resistance Test to Ground
1. Shut off the engine.
2. Set Digital Multi-Meter to OHMs.
3. Connect one Digital Multi-Meter lead to either stator lead.
NOTE: Unplug from engine harness.
4. Connect other Digital Multi-Meter lead to ground (stator frame or engine block if stator mounted to the engine
block).
5. Measure the resistance. Expected measurement should be (high resistance) innity (component at room
temperature).
6. Replace stator if measured resistance is less than innity.