Service Manual

9-16
Table of Contents
Twin Cylinder Engine Service Manual
February 2017 - Digital Edition
ENGINE ASSEMBLY
Assemble Lower End (Cont.)
Sump Cover
1. Install both alignment pints into the crankcase.
2. Install the gasket and two o-rings.
NOTE: The o-rings provide additional sealing for the pressure lubrication system.
3. Slide the sump cover over the crankshaft until against gasket and crankcase.
NOTE: Rotate the crankshaft slightly to assist assembly. DO NOT use bolts to pull cover to crankcase.
4. Install the bolts loosely. Torque in two passes, follow the torque sequence below (Figure 16):
Figure 16
3
4
5
6
7
8
9
10
1
2
Sequence for Tightening:
Sump Bolts (10)
First Pass 10 ft. lbs.
Final Torque 21 ft. lbs.