Service Manual

7-32
Table of Contents
Twin Cylinder Engine Service Manual
February 2017 - Digital Edition
ENGINE DISASSEMBLY
Disassembly Lower End (Cont.)
Piston and Connecting Rod Assembly
1. Remove the connecting rod cap bolts and cap for each rod (Figure 39).
NOTE: Each cap is stamped to match the connecting rod (Figure 40).
2. Slide the piston and rod assembly out of the cylinder, away from crankshaft.
3. Repeat for other piston assembly.
4. Re-install matching rod cap and bolts to corresponding rod.
5. Mark each piston and connecting rod assembly either cylinder #1 or #2.
Figure 39
Figure 40
The connecting rod body and
the connecting rod cap have
the same order number.