Service Manual

3-32
Table of Contents
Twin Cylinder Engine Service Manual
February 2017 - Digital Edition
TWO BARREL CARBURETOR AND FUEL SYSTEM
Assembly (Cont.)
Needle and Float
1. Install the needle onto the tang of the oat, needle tip pointed toward oat (Figure 36).
NOTE: The tang has a slight hook to retain the needle.
2. Slide the needle into the seat while aligning the pivot of the oat.
3. Install the oat pin and clamp by tightening the screw (Figure 37).
NOTE: Verify the pin is fully inserted in the groove of the carburetor body.
4. Verify the oat is free to pivot and the needle isn’t sticking.
Figure 36
Figure 37