Service Manual

9-29
Table of Contents
Reassembly
Twin Cylinder Engine Service Manual
February 2017 - Digital Edition
ENGINE ASSEMBLY
Assemble Upper End (Cont.)
Flywheel
1. Clean the taper of crank and ywheel ID taper.
2. Install the ywheel key into the slot on crankshaft taper (Figure 30).
NOTE: Long at of key should be parallel to the length of the crankshaft, not parallel to taper of
crankshaft (Figure 31).
3. Install the ywheel onto the crankshaft aligning the keyway and not contacting the stator coils under the
ywheel.
NOTE: Use caution as the ywheel magnets are strong.
Figure 30
Figure 31
Correct Incorrect
Make sure key is
installed correctly