Service Manual

38 ZT-2800
®
/ZT-3100™/ZT-3400™
AXLE SHAFT (ZT-3400)
RefertoFigure35
Disassembly
1. Remove all items beginning on page 14.
2. Remove the axle tube (165).
3. Remove the retaining ring (90).
4. Remove and discard the lip seal (96).
5. Remove the spacer (164).
6. Remove the axle shaft (94) in the direction
of arrow.
6. Remove the bearing (95).
NOTE: Removethebearingfromtheaxleshaft
onlyifwornordamaged.
Inspection
1. Inspect the splines on the axle shaft for wear
or damage. Replace if necessary.
2. Inspect the bearing (95) for wear or damage.
Replace if necessary.
Assembly
1. Assemble items in reverse order of disas-
sembly.
NOTE: To protect the lip seal from possible
damagewheninstallingintothebore
andovertheaxleshaft,applyaprotec-
tive covering over the splines, sharp
cornersand/orkeywayoftheaxleshaft
(e.g.,cellophane,tape,etc.).
Figure 35, Axle Assembly
90
96
95
94
164
165