Service Manual
16 ZT-2800
®
/ZT-3100™/ZT-3400™
It should not be necessary to adjust the transaxle
parking brake over the life of the vehicle. In the
event that the transaxle parking brake does not
hold per vehicle manufacturer’s specications,
the parking brake can be adjusted by rotating
the handle (102).
1. Note orientation of the vehicle parking brake
and linkage in the activated (locked) posi-
tion.
2. Disengage the brake.
3. Detach the vehicle parking brake linkage
from the parking brake handle (102).
4. While holding the parking brake handle
(102) rmly onto the splines, remove clip
(103) from the shaft tip.
5. Before removing the parking brake handle
(102) scribe a reference mark between the
handle and shaft tip (101).
6. Remove the brake handle (102) far enough
to rotate the handle one tooth in the angular
direction opposite the brake handle’s actu-
ated position.
7. Attach the retaining clip (103) to the brake
cam shaft.
8. Connect the vehicle parking brake linkage
to the brake handle (102).
9. Test the parking brake to assure it meets
the vehicle manufacturer’s specications.
10. It is also important to assure that the park-
ing brake is not partially engaged while the
vehicle is in the normal drive mode. This
can be conrmed by moving the vehicle to
level ground, turning the engine off, disen-
gaging the brake, engaging the bypass and
assuring that the vehicle can be moved by
pushing with reasonable effort.
Figure 10, Brake Handle Orientation
Figure 11, Brake Handle Removal
ZT-2800/ZT-3100 PARKING BRAKE ADJUSTMENT (Code 1 or 2)
WARNING
POTENTIAL FOR SERIOUS INJURY
When servicing the parking brake on
unlevel terrain, it is essential to chock
the vehicle wheels to prevent vehicle
movement.
Only
if Character #7 in the model number
code is 1 or 2.
Example: ZX-XXXX-1XXX-XXXX
Brake (Cam) Shaft (101)
Brake Handle (102)
Reference Mark
Brake Handle (102)
Brake (Cam) Shaft (101)
Clip (103)