Service Manual

CHASSIS

3-33Toro Z Master G3 3000/5000/6000 Series Service Manual

A. Cable anchor F. Lock nut

B. Threaded rod G. Pull cable threaded rod

C. Push lever this direction this direction

D. Caliper lever arm H. Hold threaded rod with

E. Standard nut (shown pliers

against swivel) I. Swivel (pivot head)

5. Try to turn the wheel hub in both directions relative

to the caliper. There should be slight movement

between them; some friction/resistance is accept-

able.

6. If there is no movement between the hub rotor and

the caliper then back off the standard nut one turn

from the swivel and repeat step 5.

7. If the hub rotor moves freely relative to the caliper,

then tighten the standard nut one turn against the

swivel and repeat step 5.

8. Once step 5 is achieved, hold the threaded rod

end with a tool and tighten the lock nut against the

standard nut. Do not allow the cable to turn when the

lock nut is tightened (Fig. 120).

Fig. 120 g. 63 G010208

B C DE F G

10. Install the RH and LH wheels on the unit and remove

both jack stands and lower the unit.

Fig. 121 PICT-8677a

9. Close the drive wheel release valve (horizontal

operating position) (Fig. 121).