Service Manual

HYDRAULIC SYSTEM

5-37Toro Z Master G3 3000/5000/6000 Series Service Manual

Flow Test Instructions

Note: The Flow Test Kit allows the dealer to easily

determine if the UHT transmission pump is

faulty by isolating the pump section from the

wheel motor (Fig. 378).

The following information describes how to

test the pump by installing the Flow Test Kit

and simulating a wheel motor load.

Warning

Portions of the procedure require testing while the

vehicle is operated in an elevated position.

Ensure vehicle is properly secured to prevent

injury to the service technician or bystanders.

Do not attempt any adjustments with the engine

running. When working around vehicle linkages,

use extreme caution.

High temperatures can be generated.

Follow all safety procedures in the vehicle owner’s

manual.

Fig. 378 9792_a

Part number 116-1373

2. On some units you can lift and tilt the seat to locate

the seat switch, on other units the seat must be

removed to get to the seat switch (Fig. 380).

Fig. 379 DSCN-4311a

Fig. 380 PICT-0398a

1. Raise the rear end of the unit and install jack stands

under the tie down loops on the frame. Remove the

RH and LH wheels from the unit (Fig. 379).