Service Manual

CHASSIS

3-5Toro Z Master G3 3000/5000/6000 Series Service Manual

3. Install the locknut. Tighten the locknut until the

Belleville washers are at, then back the nut off 1/4

turn to properly set the preload on the bearings (Fig.

015).

1. Raise the front of the machine off the ground.

2. Remove the wheel the axle bolt and nut (Fig. 017).

Fig. 015 PICT-0373a

4. Remove the plug located on the side of the caster

hub. Install a grease tting. Apply grease (No. 2

general purpose lithium base or molybdenum

grease) into the hub until it passes through the upper

bearing. Fill the top cavity with grease (Fig. 016).

Fig. 016 PICT-0375a

Fig. 017 PICT-0378a

3. Remove the wheel assembly from the fork (Fig.

018).

Fig. 018 PICT-0379a

5. Remove the grease tting and install the grease

plug.

Front Wheel Bearing Replacement

Front Wheel Bearing Removal