Service Manual

HYDRAULIC SYSTEM
5-11Toro Z Master G3 3000/5000/6000 Series Service Manual
5
11. Install the control arm bolt and washer securing the
control arm linkage to the UHT. Torque the bolt to 10
ft-lbs. (13.55 Nm) (Fig. 302).
9. Remove the oor jack.
10. Apply thread locking compound to control arm bolt
(Fig. 301).
12. Install the left hand brake cable retainer into the
cradle so that the retainer tab is installed in the slot
on the cradle (Fig. 303).
Fig. 301 PICT-8643a
Fig. 302 PICT-8644a
Fig. 303 PICT-8646a
13. Route the left hand brake cable around the cradle
and into the cable retainers (Fig. 304).
Fig. 304 PICT-8649a