Operator's Manual
Table Of Contents
- NO TITLE
- NO TITLE
- NO TITLE
- Adding Fuel
- Checking the Engine-Oil Level
- Breaking in a New Machine
- Using the Rollover-Protection System (ROPS)
- Think Safety First
- Operating the Parking Brake
- Operating the Mower Blade-Control Switch (PTO)
- Operating the Throttle
- Operating the Ignition Switch
- Using the Fuel-Shutoff Valve
- Starting and Stopping the Engine
- Using the Safety-Interlock System
- Driving Forward or Backward
- Stopping the Machine
- Adjusting the Height-of-Cut
- Adjusting the Anti-Scalp Rollers
- Adjusting the Flow-Baffle-Cam Locks
- Positioning the Flow Baffle
- Positioning the Seat
- Using the Drive-Wheel Release Valves
- Using the Side Discharge
- Transporting the Machine
- Loading the Machine
- NO TITLE
- NO TITLE
- NO TITLE
- NO TITLE
- NO TITLE
g008955
Figure24
Transport-LockPositions
1.Transportlock3.UNLOCKposition—The
mowerdeckdoesnotlock
intothetransportposition.
2.LOCKposition—The
mowerdecklocksintothe
transportposition.
AdjustingtheHeight-of-CutPin
Mowerdecksize
Height-of-cut
range
Increments
48-inchdeck38to127mm
(1-1/2to5inches)
6mm(1/4inch)
52-inchand
60-inchdecks
38to140mm
(1-1/2to5-1/2
inches)
6mm(1/4inch)
Adjusttheheight-of-cutfrom25to140mm(1to
5-1/2inches)in6mm(1/4inch)incrementsbymoving
theclevispinintodifferentholelocations.
1.MovethetransportlocktotheLOCKposition.
2.Pushonthedeck-liftpedalwithyourfootand
raisethemowerdecktotheTransportposition
(alsothe140mmor5-1/2inchcutting-height
position)asshowninFigure25.
3.Toadjust,rotatethepin90degreesandremove
thepinfromtheheight-of-cutbracket(Figure
25).
4.Selectaholeintheheight-of-cutbracket
correspondingtotheheight-of-cutdesired,and
insertthepin(Figure25).
5.Pushonthedecklift,pullbackonthetransport
lock,andslowlylowerthemowerdeck.
26