Service Manual

HYDRAULIC SYSTEM
5-31Toro Z Master G3 3000/5000/6000 Series Service Manual
5
15. Install the L-Bracket, spring, washer, and nut on the
threaded end of the brake cable (Fig. 366).
Fig. 366 DSCN-4336a
16. Install the L-Bracket with brake pin, washer, and
e-ring to the brake caliper (Fig. 367).
Fig. 367 DSCN-4314a
17. Engage the parking brake. Measure the overall
length of the compression spring (Fig. 368). The
correct length should be between 1-1/2” and 1-9/16”
(3.8 and 4.9cm). If the spring length is within this
range, no adjustment is needed. If it is not, proceed.
Fig. 368 g. 79 G016879
(Left Hand brake shown above)
A. Cable anchor E. Caliper
B. Hold threaded rod here F. Compression spring
C. Measure G. Threaded rod
D. Lock nut H. Hub
A
A
F
B C D
E
E
FG
H
H