Service Manual

HYDRAULIC SYSTEM
5-34 Toro Z Master G3 3000/5000/6000 Series Service Manual
5
The adjustment nuts are located on either side of the fuel
tank, below the seat on the pump control linkages (Fig.
373). Rotating the pump linkage nuts with a 1/2” wrench
allows ne tuning adjustments so that the machine does
not move in neutral. Any adjustments on the linkage
should be made for neutral positioning only.
Warning
Engine must be running and drive wheels must
be turning so motion control adjustment can be
performed. Contact with moving parts or hot
surfaces may cause personal injury.
Keep ngers, hands, and clothing clear of rotating
components and hot surfaces.
Fig. 373 g. 86 G009033
Adjusting the Motion Control Linkage
(Neutral Adjustment)
1. Prior to starting the engine, push the deck lift pedal
and remove the height of cut pin. Lower the deck to
the ground.
2. Raise the rear of machine up and support with jack
stands (or equivalent support) just high enough to
allow drive wheels to turn freely.
3. On some units you can lift and tilt the seat to locate
the seat switch, on other units the seat must be
removed to get to the seat switch (Fig. 374).
A. Double nuts
Fig. 374 PICT-0398a
4. Unplug the seat switch and temporarily install a
jumper wire across the terminals in the connector of
the main wiring harness (Fig. 375).
Fig. 375 DSCN-4620a
A