Service Manual

HYDRAULIC SYSTEM
5-27Toro Z Master G3 3000/5000/6000 Series Service Manual
5
19. Position a oor jack under the cradle on the side of
the machine being serviced. Raise the oor jack to
contact the cradle (Fig. 350).
Fig. 350 DSCN-4522a
23. Remove the UHT transmission from the cradle (Fig.
353).
Caution: The UHT weighs approximately 80 lbs.
(36.29kg).
Fig. 353 DSCN-4533
21. Lower the UHT transmission/cradle assembly from
the frame by lowering the oor jack. Take care that
the UHT transmission fan clears the frame.
Note: Ensure the control arm shaft clears the
frame, and the control arm linkage doesn’t
get caught between the frame and the UHT
transmission, as it is being lowered.
22. Remove the two nuts from the carriage bolts
securing the UHT transmission to the cradle (Fig.
352).
Fig. 352 DSCN-4529a
20. On the side of the machine being serviced, remove
the two bolts securing the UHT transmission to the
frame (Fig. 351).
Fig. 351 DSCN-4528a