Service Manual

HYDRAULIC SYSTEM

5-20 Toro Z Master G3 3000/5000/6000 Series Service Manual

Burnishing the Brake

3. Clear the area of any ammable material before

starting the burnishing process.

4. Rotate the drive wheel release valve to the

“operating” position (Fig. 330).

Fig. 328 PICT-8548

2. Remove the two rear wheels (Fig. 329).

Fig. 329 PICT-8550a

5. Engage the parking brake.

6. Install a 1/2” x 6” (approximately) rod or bolt through

the 2” height -of-cut hole (Fig. 331).

Fig. 331 G3CheckValveParkBrake_a

1. Raise the rear of the machine and support it with 2

jack stands placed under the right and left tie down

loops (Fig. 328).

Fig. 330 g. 36 G008957

A. Vertical: “released” B. Horizontal: “operating”

to push the machine to drive the machine