Operator's Manual

g027343
Figure90
1.Deck-liftpedal
3.Transportlock
2.Height-of-cutpin
6.Inserttheheight-adjustmentpinintothe76mm
(3inch)height-of-cutlocation.
7.Releasethetransportlockandallowthedeckto
lowertothecuttingheight.
8.Onbothsidesofthedeck,measurefromthe
levelsurfacetothefronttipoftheblade(position
A)asshowninFigure91.
Note:Themeasurementshouldread7.6mm
(3inches).
g024245
Figure91
1.7.6cm(3inches)at
positionAiscorrect.
3.Measureherefromthe
bladetiptothehard
surface.
2.8.3cm(3-1/4inches)at
positionBiscorrect.
4.MeasureatpositionAand
Bonbothsides.
9.Ifneeded,loosenthewhizlocknutontheside
oftheyokeandthejamnutontop.Fine-tune
thescrewadjusterbyturningittoget7.6cm(3
inches)height(seeFigure92).
Note:Toincreasetheheight,turntheadjuster
screwclockwise;todecreasetheheight,turnit
counterclockwise.
Note:Ifthefrontdecklinksdonothaveenough
adjustmenttoachieveaccuratecutheight,you
canutilizethesingle-pointadjustmenttogain
moreadjustment.
63