Service Manual

CHASSIS

3-61Toro Z Master G3 3000/5000/6000 Series Service Manual

13. Secure the front pump linkage assembly to the LH

motion control assembly with a bolt, washer and nut.

Note: The washer must be installed between the LH

motion control assembly and the ball joint on

the front pump linkage assembly (Fig. 216).

Fig. 216 DSCN-4470a

14. Install the two bolts and nuts retaining the LH

steering handle assembly to the LH motion control

lever (Fig. 217).

Fig. 217 DSCN-4459a

15. For adjustments on the control handles and the

motion control neutral lock, see “Adjusting the

Motion Control Neutral Lock Pivot” on page 3-53

and “Adjusting the Control Handle Position” on page

3-53.

17. Start the unit, disengage the park brake lever, and

run for about 5 minutes operating the forward and

reverse handle forward/reverse. Move the motion

control lever to the neutral position and observe the

rear tire for movement. If the rear tire creeps in the

forward position, perform a neutral adjustment. A

slight creep in reverse is allowable. See “Adjusting

the Motion Control Linkage (Neutral Adjustment)” on

page 5-34.

Fig. 218 DSCN-4454a

16. Install the 2 screws retaining the LH motion control

cover assembly (Fig. 218).