Service Manual

HYDRAULIC SYSTEM
5-30 Toro Z Master G3 3000/5000/6000 Series Service Manual
5
11. Install the control arm bolt and washer securing the
control arm linkage to the UHT transmission. Torque
the bolt to 10 ft-lbs. (13.55 Nm) (Fig. 362).
Fig. 362 DSCN-4554a
12. Slide the wheel hub onto the UHT transmission shaft
aligning the keyway in the wheel hub with the key in
the UHT shaft. Loosely install the nut (Fig. 363).
Note: Do not use anti-seize compound on the wheel
hub.
Fig. 363 DSCN-4555a
13. Slide the brake cable into the cable anchor slot on
the transmission (Fig. 364).
Fig. 364 DSCN-4325a
14. Install the end of the brake cable through the cable
anchor and install an e-ring (Fig. 365).
Fig. 365 DSCN-4361a