Service Manual

ENGINE

4-7Toro Z Master G3 3000/5000/6000 Series Service Manual

Engine Installation

1. Place the engine approximately 6” above the frame

in the engine bay area.

2. Install the battery ground cable and wiring harness

ground wire to the starter motor bolt (Fig. 241).

Fig. 241 DSCN-0043a

4. Plug the wiring harness plug into the engine wiring

harness plug connector (Fig. 243).

Fig. 243 DSCN-0049a

5. Lower the engine to the frame.

6. Align the four holes of the engine base to the frame

using 4 bolts and Belleville washers. Torque the

bolts to 30 ± 3 ft-lbs. (40.7 ± 4.07 Nm) (Fig. 244).

Fig. 244 DSCN-0055

3. Install red positive cable and red wire to the bottom

of the starter solenoid (Fig. 242).

Fig. 242 DSCN-0050a