Service Manual

HYDRAULIC SYSTEM

5-12 Toro Z Master G3 3000/5000/6000 Series Service Manual

17. Slide the brake cable swivel through the brake

caliper and loosely install a nut onto the swivel (Fig.

307).

Fig. 305 PICT-8659a

15. Repeat steps 12 and 14 to install the right hand

brake cable.

16. Slide the wheel hub onto the UHT shaft aligning the

keyway in the wheel hub with the key in the UHT

shaft. Loosely install the castle nut (Fig. 306).

Note: Do not use anti-seize compound on the wheel

hub.

Fig. 306 PICT-8661a

Fig. 307 PICT-8663a

18. Position the brake caliper onto the wheel hub

aligning the holes in the brake mount plate with the

mounting holes in the UHT. Slide a washer between

the UHT and the brake mount plate. Install a bolt

ensuring the washer is captured and tighten the bolt

(Fig. 308).

Fig. 308 PICT-8665a

14. Pull the boot back and slide the brake cable into

the slot in the cable anchor bracket. Slide the boot

up and over the end of the cable retainer to ensure

water is sealed out (Fig. 305).