Service Manual

HYDRAULIC SYSTEM
5-21Toro Z Master G3 3000/5000/6000 Series Service Manual
5
7. Start the mower while in the operating position.
8. Release the parking brake so the handle rests on
the 1/2” x 6” rod or bolt.
9. Move the throttle over to the full throttle position.
10. Move both motion control levers to the full forward
position and hold for 15 seconds.
11. Move both motion control levers to the full reverse
position and hold for 15 seconds.
12. Turn off the engine and completely release the
parking brake by removing the 1/2” x 6” rod or bolt.
13. Allow the hubs to cool until they are cool enough to
safely touch.
14. Rotate the drive wheel release valve to the “release”
position (Fig. 332).
15. Ensure the parking brake is disengaged.
16. Using your thumb, push the caliper lever arm for-
ward to engage the brake pads on the wheel hub
until the lever stops (Fig. 333).
Note the order of the standard nut and the lock nut
on the end of the brake cable.
A. Standard nut B. Lock nut
Fig. 333 PICT-8679a
Fig. 332 g. 36 G008957
A. Vertical: “released” B. Horizontal: “operating”
to push the machine to drive the machine
A
B
A
B